Search found 6 matches
- Tue Jan 26, 2021 1:54 pm
- Forum: M3-ID
- Topic: Octoprint module SD card access?
- Replies: 14
- Views: 55286
Re: Octoprint module SD card access?
I've been waiting for a MakerGear forked Octoprint new release for over two years (see my thread in the software forum). 1.3.6 can't run several plugins that I want to install for improvements to our printing processes.
- Tue Jan 26, 2021 1:53 pm
- Forum: M3-ID
- Topic: Octoprint module SD card access?
- Replies: 14
- Views: 55286
Re: Octoprint module SD card access?
I've been waiting for a MakerGear forked Octoprint new release for over two years (see my thread in the software forum). 1.3.6 can't run several plugins that I want to install for improvements to our printing processes.
- Tue Jan 26, 2021 1:44 pm
- Forum: Software
- Topic: Octoprint version
- Replies: 5
- Views: 22410
Re: Octoprint version
1.4.0-mgalpha pre-release June 25,2020. No new release of the MG fork in almost 3 years. The official Octoprint is at 1.5.3, just released a week ago.
Is there any way to run the official Octoprint with MG M3-ID?
Is there any way to run the official Octoprint with MG M3-ID?
- Fri Jun 26, 2020 7:01 pm
- Forum: Tech Support
- Topic: SD card full from timelapses - Octoprint doesn't fully load
- Replies: 4
- Views: 7045
Re: SD card full from timelapses - Octoprint doesn't fully load
With much gyrations, I was finally able to fix the SD - not sure if it was because of the card being filled up, but one of the "start_...elf" boot files appeared to have gotten corrupted. After replacing them with new copies from a fresh Raspbian install on another SD, I was able to boot fully into ...
- Mon Jun 22, 2020 1:25 pm
- Forum: Tech Support
- Topic: SD card full from timelapses - Octoprint doesn't fully load
- Replies: 4
- Views: 7045
SD card full from timelapses - Octoprint doesn't fully load
I'm having an issue where it appears the SD card has filled up with timelapses, and now Octoprint doesn't fully load. It brings up the basic interface, but doesn't connect to the printer, and clicking the login button doesn't do anything. (Makergear M3-ID) Prior to this symptom, I had tried to uploa...
- Thu Jun 27, 2019 1:28 pm
- Forum: Software
- Topic: Octoprint version
- Replies: 5
- Views: 22410
Octoprint version
Is there any anticipated releases for newer versions of the Makergear fork of Octoprint? Current released version 1.3.6 was in March over a year ago, and the 1.3.10.1 pre-release test build hasn't been updated since December. The original Octoprint is at 1.3.11 and enables use of a lot of newer plug...