Up and running. Yep, the one you linked jsc. Needed to take time to read it and had a bit of information overload.
Thank you.

Just found this on the M2 wiki page. http://makergear.wikidot.com/m2-firmware While not an official revision, one may end up with a 24V/40W V3B hotend, on a 19V M2. This configuration requires a PID setting of P48.89 I3.41 D175.43, and a PID_MAX setting of 400. Firmware with this configuration, and ...

Jin, yes dual power supply unit of 12 vdc for heater bed and 19 vdc for extruder, stepper and logic. Tim, I was thinking firmware based problem and was wondering if there was something that was clamping it. I will look at Jim's link on setting the pid loop. Jim, thanks for the link. I will take a lo...

I received a new V3b extruder Friday. It is the 19 vdc version. I have installed it and increased heats in Slic3r to 215 deg. I have tried running from Repetier Host and straight from SD card with the same results. The extruder heats up to 202 to 209 degrees and holds. I have changed the settings an...

I like MitchL use Alibre Design PE (Personal Edition). I was able to purchase it for a reduced rate of $99 (regularly $199) when it was on sale. Have never had a problem with exporting *.STL files and slicing them. It works much like SolidWorks. One good thing with Design is that you can create mode...