OK so I'm getting further along getting my used m2 setup. I've finally gotten it to heat up and jog x and y axis but z is dead. When I connect z to x or y it works and if i connect x or y to z output its dead for those too. I assume this means I have a bad board? In any case is there a way to reassi...

Yes I got a good deal awith the awareness it was an older model I may have to upgrade anyway so thats fine. So to be clear, the v3b hot end is a worthwhile upgrade in addition to hbp and 24v upgrades?

shouldn't i still be able to jog the axis's though?

its 0.

its the v3 not v3b hot end. its the 12v/19v dual power. I haven't extruded any material. I haven't been able to get it to heat up yet. it won't do anything but initialize and give me that error. also maybe of interest when its not connected via usb before it initializes with the software the upper f...

it throws the m999 error as soon as it initializes when i connect via simplify3d. I'll try to wiggle everything though. thanks.

I just bought a used m2 and can't get it to work. Im using simplify3d software and have also tried to connect using print run. Same results. I can't get it to jog or heat up. It will home x and y axis but not z and I cannot manually jog through the software after it homes. The software is communicat...