I don'the know much about slic3r but I tried printing with a few different programs. but when I bought "S3D" I seemed to be getting much nicer prints and the interface is very easy to uwe and understand I also tried a lot of modeling programs but I chose "Cubify Invent" after failing to understand t...

I appreciate the comments and I grasp it a bit better. Like some have suggested I tried printing vertically but what works best is just making the text bigger, 3x3mm just was to small for the detail and the spacing was too close together - my fault for lack of understanding. I understand this techno...

I assumed that I would get a little better resolution on the lettering, I guess I will just have to make it larger or try fiddling with settings till I get a acceptable resolution. Really not sure what to play with setting wise but I'm up to the task as long I don't break my printer

I am very new to this and would like to make some small 40mm parts with "text" on them, I have tried a couple prints out in S3D and the part prints fine but the text is almost never readable. I have tried printing in both stock settings of Medium and High and High shows a improvement but still not q...