If it just started, I'd actually say your filament is too humid, and the moisture is preventing a good melting of the plastic...I'd suggest baking your filament. I will hold off on baking the filament for now, just because my parts are printing all the way through and I don't have an oven available...

How fast are you moving the extruder gear ? The extrusion speed is the default on the VIKI LCD panel, I believe it's the 25mm/s indicated by the parameter 'Vmax e' on the screen. Before attempting to print again, I used a strand of steel wire to try and clean out the nozzle in case a clog was my pr...

Thanks for your replies over the weekend! I got back to the printer this morning and have tried out a couple of your suggestions so far, the results are as follows: unplug the m2, let it sit a min then plug it back in so the rambo reboots. check the cable and little white plug going into the extrude...

Thanks for your replies over the weekend! I'll give all these suggestions a try this morning and report back.

Hi there, The last few prints from our M2 have failed in that the filament stops being extruded after the first 10-20 layers and my investigation lead me to the extruder motor. After a brief moment of smooth extrusion, the filament drive begins to get jumpy as it rotates clockwise. Filament still ex...