Search found 7 matches
- Sun Jun 06, 2021 5:09 pm
- Forum: Tech Support
- Topic: PETG profile
- Replies: 2
- Views: 5972
PETG profile
Need PETG settings, for M3. Searched.... no luck
- Wed Nov 14, 2018 9:47 pm
- Forum: M3-ID
- Topic: Probe bent and running off bed
- Replies: 1
- Views: 5744
Probe bent and running off bed
I've been printing a ton of stuff on my new machine... Yesterday, I was getting failed prints and saw that the probe was bent. When a print starts, the head will travel to the far right and bump into the other head... It has been doing this all along, but not causing any problems. Now its not calibr...
- Wed Nov 14, 2018 8:59 pm
- Forum: M3-SE
- Topic: Probe is getting bent
- Replies: 2
- Views: 17118
Re: Probe is getting bent
oops... thanks for catching
- Wed Nov 14, 2018 6:29 pm
- Forum: M3-SE
- Topic: Probe is getting bent
- Replies: 2
- Views: 17118
Probe is getting bent
<t>I've been printing a ton of stuff on my new machine... Yesterday, I was getting failed prints and saw that the probe was bent. When a print starts, the head will travel to the far right and bump into the other head... It has been doing this all along, but not causing any problems. Now its not cal...
- Fri Feb 24, 2017 6:28 pm
- Forum: How-to/Guides/Tips
- Topic: Tip on preventing edges from lifting?
- Replies: 3
- Views: 8309
Tip on preventing edges from lifting?
I'm on my 4th or 5th spool of material, had great success so far. ABS and PLA... When doing something big and flat, I am getting a little lift up on the edges. Same part with PLA or ABS, same thing. I tried hairspray... no change. I just read a thread on setting for PETG and the person mentioned pri...
- Fri Dec 16, 2016 8:28 pm
- Forum: General Discussion
- Topic: When should fan on bed come on?
- Replies: 1
- Views: 3875
When should fan on bed come on?
The fan aimed at the bed never comes on. using PLA and ABS. Not sure when this is necessary?? I haven't swapped plugs from the one on the extruder yet. Just want to know when to expect the two fans to come on. Search did not yield answer, sorry for the newb question....
- Fri Dec 16, 2016 8:24 pm
- Forum: General Discussion
- Topic: How often should I re-calibrate?
- Replies: 3
- Views: 6059
How often should I re-calibrate?
I've gone through about two spools now, PLA and ABS. This thing has been going non-stop. Recently, I've had a few failed prints. Part of the problem is that the ABS isn't sticking to the kapton sheets. Is hairspray the solution? Curious if I should calibrate the machine like I did when I first bough...