Search found 53 matches
- Sat May 10, 2014 5:06 pm
- Forum: Printed Object Showcase
- Topic: tricopter prototype
- Replies: 6
- Views: 12691
Re: tricopter prototype
not accusing. i'm being impressed! that came out very clean. nice work.
- Sat May 10, 2014 7:42 am
- Forum: Printed Object Showcase
- Topic: tricopter prototype
- Replies: 6
- Views: 12691
Re: tricopter prototype
is that a 90 degree overhang printed with no support?
- Sat May 10, 2014 7:38 am
- Forum: How-to/Guides/Tips
- Topic: some handy tools for cleaning the hot end
- Replies: 24
- Views: 36937
Re: some handy tools for cleaning the hot end
thanks jim! totally could have used these earlier today. would have saved me a few hours time not having to improvise.
ordered and on their way.
ordered and on their way.
- Sat May 03, 2014 6:58 pm
- Forum: Tech Support
- Topic: Maker Gear M2, extruder clogging
- Replies: 13
- Views: 26076
Re: Maker Gear M2, extruder clogging
I just finished dealing with this same problem. The issue in my case was caused by too much resistance in the path from the spool to the extruder as well as the filament on the spool having crossed over itself a few times causing something of a really loose knot. The teeth of the extruder motor did ...
- Sat Apr 12, 2014 11:00 pm
- Forum: Tech Support
- Topic: Problem with extruder
- Replies: 8
- Views: 12025
Re: Problem with extruder
is the hot end heated up? if the extruder motor isn't even turning it may be due to the hot end not being at the correct temp.
- Sat Apr 12, 2014 10:57 pm
- Forum: Printed Object Showcase
- Topic: Twist vase
- Replies: 8
- Views: 15357
Re: Twist vase
nice! i think the one i printed took about 4.5 hours. do you guys know of a way to get vase mode to print two layers for the wall instead of 1? the walls seem pretty flimsy as is.
- Sat Apr 12, 2014 8:30 pm
- Forum: Printed Object Showcase
- Topic: Twist vase
- Replies: 8
- Views: 15357
Twist vase
Ok I'll go first. This is one of the many twisted vases on Thingiverse. Printed it more for learning than anything else, but it turned out alright I think.
- Fri Apr 11, 2014 10:53 pm
- Forum: Software
- Topic: s3d 2.1 is out
- Replies: 26
- Views: 41247
Re: s3d 2.1 is out
did you remove the previous install before you installed the new version?
- Fri Apr 11, 2014 10:08 pm
- Forum: General Discussion
- Topic: Hello
- Replies: 15
- Views: 25876
Re: Hello
Thanks for getting this setup Rick!
- Fri Apr 11, 2014 8:55 pm
- Forum: Software
- Topic: M2 Slic3r settings
- Replies: 12
- Views: 54808
Re: M2 Slic3r settings
thanks ketil! this will help speed up the leveling process quite a bit.