Hot end 2-pin connector source?
Posted: Sat Aug 16, 2014 8:55 pm
Is there a source for just the M2 extruder hot end heat/temperature 2-pin plugs? Thanks!
Found 'em.
Duh.
http://www.makergear.com/products/plast ... ment-parts
MakerGear Forum
The Place To Discuss MakerGear 3D Printers!
http://www.forum.makergear.com/
Hot end 2-pin connector source?
Page 1 of 1
Re: Hot end 2-pin connector source?
Posted: Sat Aug 16, 2014 8:57 pm
Re: Hot end 2-pin connector source?
Posted: Sun Aug 17, 2014 12:52 am
will, keep in mind there are 2 types of molex connectors. the one on the hot end and the one for the fans. be sure to make a note which one you need when ordering or send karen a quick email after you order to let her know.
Re: Hot end 2-pin connector source?
Posted: Wed Aug 20, 2014 9:05 pm
Jim, I missed your reply, unfortunately they have already shipped. I was noticing that detail myself this morning and felt that at least I had a 50/50 chance! They should be here in a day or so. I ordered 4 pairs, so maybe I'll get some of each. 