Second print fan?
Posted: Mon Aug 18, 2014 4:10 pm
Hi,
I'm thinking of adding a second fan for the bed. It would sit behind the filament motor, quite symmetrical to the front fan.
Any ideas on this? I noticed a better result on the part with a fan when printing a sphere.
I think it should be OK to power it using a Y splitter from the front 50mm fan.
I'm thinking of adding a second fan for the bed. It would sit behind the filament motor, quite symmetrical to the front fan.
Any ideas on this? I noticed a better result on the part with a fan when printing a sphere.
I think it should be OK to power it using a Y splitter from the front 50mm fan.