Page 1 of 1
my billet aluminium print head
Posted: Sun Jul 26, 2015 1:24 pm
by waw3d
expensive... but I routinely print with a 0.25 mm nozzle.... fanless... no model fan... no extruder fan... and no heated bed...
Re: my billet aluminium print head
Posted: Sun Jul 26, 2015 2:34 pm
by ednisley
At a glance, the print quality shown in the fuzzy picture in the other thread doesn't seem exceptional for a well-tuned M2.
If you provide more (read that as any) information about your "very modified M2", you'll have far more credibility...
Re: my billet aluminium print head
Posted: Sun Jul 26, 2015 3:19 pm
by sthone
This guy must work for Fox News because this thread reads like one of their news articles.
Breaking News Title - Man attacked by mutant man eating killer purple shark while riding solar powered nuclear homemade 3d printed surf board.
Artical - Today at west beach there was a shark attack. The end.