colorfabb xt

The place to discuss filament...
Post Reply
User avatar
PcS
Posts: 667
Joined: Mon Mar 09, 2015 12:19 pm
Location: Michigan

colorfabb xt

Post by PcS » Fri Apr 24, 2015 12:33 pm

If anybody has a profile for this and would like to post it I would appreciate it. I am getting mixed results and having a hard time dialing this in for some reason . Thanks in advance !
Top
User avatar
jimc
Posts: 2888
Joined: Wed Apr 09, 2014 11:30 pm
Location: mullica, nj
Contact:
Contact jimc

Re: colorfabb xt

Post by jimc » Fri Apr 24, 2015 2:06 pm

Pat, were you using an e3d hotend? V3b, v4...i cant remember
Top
rsilvers
Posts: 185
Joined: Wed Apr 09, 2014 11:07 pm

Re: colorfabb xt

Post by rsilvers » Fri Apr 24, 2015 2:51 pm

Just print it at 250C and slow down the speed to 3200. I am not sure what is best for layer height, but I use 0.2mm.

Make sure to do an extrustion-multiplier test.
Last edited by rsilvers on Fri Apr 24, 2015 4:16 pm, edited 1 time in total.
Top
User avatar
PcS
Posts: 667
Joined: Mon Mar 09, 2015 12:19 pm
Location: Michigan

Re: colorfabb xt

Post by PcS » Fri Apr 24, 2015 3:32 pm

V4 hot end l jimc . I will give that a try rs .Thanks.
Top
Post Reply

Return to “Filament”