Page 1 of 1
PSA: 5lb spools of black Ultimachine PLA @ $53
Posted: Thu Jul 02, 2015 5:33 pm
by insta
They're on clearance for "texture". I've gotten the textured rolls before, the surface is slightly rougher than normal. Completely inconsequential, and it prints fine.
Re: PSA: 5lb spools of black Ultimachine PLA @ $53
Posted: Wed Jul 29, 2015 10:17 pm
by insta
i bought them all suckers
edit: i bought most of them not all of them
Re: PSA: 5lb spools of black Ultimachine PLA @ $53
Posted: Wed Jul 29, 2015 10:30 pm
by Jules
Is the Ultimachine PLA a lot better than Hatchbox or eSun?
Re: PSA: 5lb spools of black Ultimachine PLA @ $53
Posted: Wed Jul 29, 2015 11:28 pm
by insta
Jules wrote:Is the Ultimachine PLA a lot better than Hatchbox or eSun?
It's what I'm most used to. Get a 5lb spool of black, try it out
Re: PSA: 5lb spools of black Ultimachine PLA @ $53
Posted: Wed Jul 29, 2015 11:58 pm
by Jules
insta wrote:It's what I'm most used to. Get a 5lb spool of black, try it out
I'd love to try it, but I've got 2½ rolls of black PLA already, and a couple of rolls of black PETG. (And no more room for spools.) Where the heck does everyone store their stuff? I can't invite anyone into my office anymore, i can only get in by walking
around the buckets of filament!
Re: PSA: 5lb spools of black Ultimachine PLA @ $53
Posted: Thu Jul 30, 2015 12:03 am
by lem
i can only get in by walking around the buckets of filament!
Print faster.
Re: PSA: 5lb spools of black Ultimachine PLA @ $53
Posted: Thu Jul 30, 2015 12:13 am
by Jules
Re: PSA: 5lb spools of black Ultimachine PLA @ $53
Posted: Thu Jul 30, 2015 11:02 pm
by insta
Re: PSA: 5lb spools of black Ultimachine PLA @ $53
Posted: Fri Jul 31, 2015 12:03 am
by Jules
Yeah.....that's pretty much what mine looks like now.
My office is unfortunately right next to the front door. (People already suspected i was weird.......Now they're sure of it.)