Problems with Ninjaflex warping badly off the build surface
Posted: Sat Mar 05, 2016 7:40 pm
hahaha jk 
Don't be targeting the little Bambis insta, it's not sporting. MakerGear Forum
The Place To Discuss MakerGear 3D Printers!
http://www.forum.makergear.com/
Problems with Ninjaflex warping badly off the build surface
Page 1 of 1
Re: Problems with Ninjaflex warping badly off the build surf
Posted: Sat Mar 05, 2016 8:15 pm
Don't be targeting the little Bambis insta, it's not sporting. Re: Problems with Ninjaflex warping badly off the build surf
Posted: Sun Mar 06, 2016 3:55 pm
Have you tried chilling the bed to 0°Kelvin?
Re: Problems with Ninjaflex warping badly off the build surf
Posted: Sun Mar 06, 2016 4:09 pm
Snort! (I know some people who move like they are at 0°K.)willnewton wrote:Have you tried chilling the bed to 0°Kelvin?