Page 1 of 1
NinjaFlex bridging (serious ninjaflex post this time)
Posted: Thu Mar 10, 2016 6:56 pm
by insta
how
pls
It does not bridge. I need it to bridge at least an inch.
Printing 15mm/sec @ 0.5mm nozzle, 0.2mm layers, 250C, 80C steel bed with hairspray, 1.38 extrusion multiplier. I cannot find any combination of bridging multiplier and speed that causes the threads to not break off or sag straight down.
Re: NinjaFlex bridging (serious ninjaflex post this time)
Posted: Thu Mar 10, 2016 7:20 pm
by Jules
You using S3D?
Re: NinjaFlex bridging (serious ninjaflex post this time)
Posted: Thu Mar 10, 2016 7:22 pm
by insta
Yep, but I'm not married to it.
Re: NinjaFlex bridging (serious ninjaflex post this time)
Posted: Thu Mar 10, 2016 7:27 pm
by Jules
Try increasing these:
Bridging Extrusion Multiplier: 150%
Extra inflation distance: 1.0 mm
Bridging Speed Multiplier: 150%
And lower the unsupported area threshold to 2 mm.
Might not work, but those a similar to what i experimented with in PETG, and the ninja has got to be worse than that.
Re: NinjaFlex bridging (serious ninjaflex post this time)
Posted: Thu Mar 10, 2016 9:25 pm
by insta
Caused a buckle (plastic going too fast)
Re: NinjaFlex bridging (serious ninjaflex post this time)
Posted: Thu Mar 10, 2016 9:59 pm
by Jules
Whoops! (Maybe designing some manual support?)
Re: NinjaFlex bridging (serious ninjaflex post this time)
Posted: Thu Mar 10, 2016 11:11 pm
by insta
Right now I'm printing bridging torture tests ... I can do 20mm "passably", but fails pretty hardcore on 30mm.
Re: NinjaFlex bridging (serious ninjaflex post this time)
Posted: Fri Mar 11, 2016 12:57 am
by jimc
waiting to see what you come up with here. bridging was one thing i have never really needed to do with ninjaflex.......yet
Re: NinjaFlex bridging (serious ninjaflex post this time)
Posted: Mon Mar 14, 2016 12:29 am
by insta
I didn't get anywhere. I'm back to thinking that Ninjaflex is hateful