MakerGear Forum

The Place To Discuss MakerGear 3D Printers!
http://www.forum.makergear.com/

Retract/Extrude mixed on Tool-1

http://www.forum.makergear.com/viewtopic.php?f=13&t=3442

Page 1 of 1

Retract/Extrude mixed on Tool-1

Posted: Sat Mar 05, 2016 6:52 pm
by scampa123
I just setup my dual and was starting to load the filament...I noticed my Tool-1 extruder is extruding when I tell it to retract!

Is this just a wire reversed or something?? How can I fix this?

Thanks!!

Re: Retract/Extrude mixed on Tool-1

Posted: Sat Mar 05, 2016 6:56 pm
by scampa123
I just found this post and will give it a try!

viewtopic.php?f=13&t=3150

Re: Retract/Extrude mixed on Tool-1

Posted: Sat Mar 05, 2016 8:37 pm
by scampa123
Yup that fixed it!
All times are UTC+01:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/