Change Startup Order of Probe
Posted: Wed Jun 09, 2021 2:25 pm
Hi. I just upgraded from an M2 Rev.E to the M3 ID. One of the benefits to the M3 ID over the M2 is the auto leveling. This has also created an annoyance.
Since the startup procedure is
Is there a way to change this startup sequence so that the bed leveling takes place BEFORE the nozzles warm up? I looked at the startup script, and while I don't completely understand every line, I didn't see one that looked like a bed leveling command.
I am using Simplify 3D
Help?
Since the startup procedure is
- Warm Bed
Warm Nozzles
Level Bed
Print
Is there a way to change this startup sequence so that the bed leveling takes place BEFORE the nozzles warm up? I looked at the startup script, and while I don't completely understand every line, I didn't see one that looked like a bed leveling command.
I am using Simplify 3D
Help?