Hi. I just upgraded from an M2 Rev.E to the M3 ID. One of the benefits to the M3 ID over the M2 is the auto leveling. This has also created an annoyance.
Since the startup procedure is
- Warm Bed
Warm Nozzles
Level Bed
Print
This creates a startup oozing problem since it takes 1-2 minutes for the bed to level, the hot ends start oozing and depositing material as the bed is moving around. I have to constantly clean up after this with tweezers before the print starts. Not a great process.
Is there a way to change this startup sequence so that the bed leveling takes place BEFORE the nozzles warm up? I looked at the startup script, and while I don't completely understand every line, I didn't see one that looked like a bed leveling command.
I am using Simplify 3D
Help?