Page 1 of 1
The right way to remove a stuck print job from glass M2
Posted: Sat Mar 14, 2015 7:44 am
by jaguar3d
Hello all! well i received my M2 today and am using the Simplify3D software. All is going great, however i have a nice printjob with a wide round surface and it is really stuck to the glass. I've tried a few minor things and don't want to damage the glass with a screwdriver or something like that. What is the best way to remove it. For now i'm leaving it until i get some help. I love this thing and want to take care of it.
Thanks!
Re: The right way to remove a stuck print job from glass M2
Posted: Sat Mar 14, 2015 9:38 pm
by insta
How'd you stick it down? You can try the freezer.
Re: The right way to remove a stuck print job from glass M2
Posted: Sat Mar 14, 2015 10:08 pm
by jsc
Yes, just stick it in the freezer, it should come off by itself. You should also get a sharpened joint knife or a razor blade (
viewtopic.php?f=4&t=1977) to get under the corners and pry it off.
Re: The right way to remove a stuck print job from glass M2
Posted: Sun Mar 15, 2015 2:01 am
by jaguar3d
Thank you both for the great suggestions. i will try the freezer to see if it comes off on it's own and then try a razor or maybe something like a painters chisel so as to try not to damage the glass. THANKS!
Re: The right way to remove a stuck print job from glass M2
Posted: Sun Mar 15, 2015 2:11 am
by insta
For what it's worth it only takes an hour or so in the freezer.
You also never did say what you stuck it to the bed with
