Page 1 of 1
Greetings!
Posted: Sat May 30, 2015 11:43 pm
by mr_friendly
I just today received my Makergear M2 assembled unit and (thanks in large part to this community) have gotten up and running very quickly. I still have quite a bit to learn about this machine, but I just wanted to say hello and to thank the community and forum regulars for providing such a great resource for 3D printing newbies such as myself. Kudos!
Cheers,
Rob
Re: Greetings!
Posted: Sun May 31, 2015 3:10 am
by jimc
welcome rob
Re: Greetings!
Posted: Sun May 31, 2015 3:39 am
by Jules
Hey Rob! Welcome to the group! (And buckle down for the ride!)
Re: Greetings!
Posted: Sun May 31, 2015 4:10 am
by Slipshine
welcome
Re: Greetings!
Posted: Sun May 31, 2015 10:22 pm
by jdacal
Welcome!
Re: Greetings!
Posted: Mon Jun 15, 2015 6:14 pm
by Dale Reed
Rob,
Welcome to the fun! Yes, any reading you did here before your M2 arrived was very helpful, I'm sure. It was for me when I was starting out.
And we ALL still have A LOT to learn about 3D printing. Fortunately, we have a strong group here -- well connected to other things happening in 3D printing, 3D CAD, etc., etc., willing to share, and always willing to help. This board has a VERY high helpful-to-hurtful ratio (dang near infinite) compared to other forums (fora?) I've been on. You've chosen well, padawan!
Dale
Re: Greetings!
Posted: Tue Jun 16, 2015 12:23 am
by TheMaker
Welcome to the forum, and congratulations! If you run into any problems, the people here are super helpful. Enjoy your new M2!