Page 1 of 1
Extruder Motor Mount Broke
Posted: Tue Jul 14, 2015 1:25 am
by dklassen
Can't believe it, it actually broke today after 9 months and a lot of prints. Did I follow peoples advice and print extra parts when I got the M2? Of course not. Well, the old Printerbot Simple Metal to the rescue.
Re: Extruder Motor Mount Broke
Posted: Tue Jul 14, 2015 3:33 am
by jsc
If it's not too bad, just try gluing it up enough for one print.
Re: Extruder Motor Mount Broke
Posted: Tue Jul 14, 2015 2:41 pm
by Jules
I've got a couple of spares - you're welcome to one that came with the M2 if you need it. (I'm currently on a PETG mount that i printed - higher infill.)
Re: Extruder Motor Mount Broke
Posted: Tue Jul 14, 2015 3:40 pm
by dklassen
Thank you very much, I appreciate the offer. I got one printed out late last night on my Simple Metal. Haven't used it in months but I'm always amazed at the quality that little printer produces. I should have it all back together tonight.