MakerGear Forum

http://www.rpgnow.com/product/173704/DR ... lider_view

Wondering if these 28mm filament printed minis are smoothed some how?
Or do you think he just Photoshopped them? They appear melted.

Has any used any vapor smoothing or any smoothing techniques on such small organic prints?
How were your results?

Thanks

wisdomknight wrote:They appear melted.

The top picture looks like a low-resolution image of a rather poor 3D print: those horizontal lines shouldn't be there.

The group image looks more like 3D model renderings, rather than printed pieces.