MakerGear Forum

Right now Im using the black PLA that came packed with the M2.
Temperatures 220 extruder and 70 bed (hairspray)

Im trying to print a part at .050mm.

What is the recommended settings for something at this resolution?

It starts off good then either starts pullin off bed after a couple minuted or becomes a mess.

I have a .35mm nozzle and I can print successfully at .100mm or higher but thats it

Any help would be appreciated.

ok went up to .100mm and still popping off bed after a few minutes

would the tape be better at these resolutions?

reduced temps to 190 and 45, same thing starts off with perfect layeres.
Then after a couple min starts popping off everywhere, way worse at these lower temps!

Popping off the bed (at 60C) means you're too high off the bed. Adjust accordingly.

now tried 220 and a 75 bed.
way better hotter but still starts coming off .

done for the day.

insta wrote:Popping off the bed (at 60C) means you're too high off the bed. Adjust accordingly.

the nozzle?

wisdomknight wrote:

insta wrote:Popping off the bed (at 60C) means you're too high off the bed. Adjust accordingly.

the nozzle?

Yep. Set your first layer height to 400% or so.

thank you I will try!

insta wrote:

wisdomknight wrote:

insta wrote:Popping off the bed (at 60C) means you're too high off the bed. Adjust accordingly.

the nozzle?

Yep. Set your first layer height to 400% or so.

Working great now!
Thank you soo much!