problem with first layers
Posted: Sat Jul 25, 2020 8:39 am
Hi everyone, this is my first message to the forum and problem with my maker gear printer.
A corner of my model bends away from the bed glass. I assume that this happens half way or when the bed is cooling. Everything seems fine when the layers are been printed. but the "bend" is there when I take my model out.
I am having these problem consistently with all my models.
I am printing with PLA
Not sure why and any suggestion would be greatly appreciated .
Please check the images
https://www.dropbox.com/s/56m9yrelj3mxl ... 0.jpg?dl=0
https://www.dropbox.com/s/5a2cndnbmqwez ... 8.jpg?dl=0
Thanks in advanced
Diego
A corner of my model bends away from the bed glass. I assume that this happens half way or when the bed is cooling. Everything seems fine when the layers are been printed. but the "bend" is there when I take my model out.
I am having these problem consistently with all my models.
I am printing with PLA
Not sure why and any suggestion would be greatly appreciated .
Please check the images
https://www.dropbox.com/s/56m9yrelj3mxl ... 0.jpg?dl=0
https://www.dropbox.com/s/5a2cndnbmqwez ... 8.jpg?dl=0
Thanks in advanced
Diego