MakerGear Forum

Here is my latest project that was printed on the M2:

http://www.kwartzlab.ca/2014/05/cnc-rou ... dust-shoe/

http://www.thingiverse.com/thing:325805



Karl

Karl,

VERY nice. I see some 3D printed dryer vent doors in my future. Especially for 2 dryers on one vent in the cold weather here in a Cleveland winter. I can tweak the weight of the door flap by adjusting infill so it isn't too heavy (thus blocking flow) and isn't too light (thus not having enough weight force to flap shut properly when the dryer is off). Thanks for the inspiration!

Dale