Page 1 of 2
Viking Sword
Posted: Wed Apr 22, 2015 3:10 am
by jereywolf
This is modeled after Lagertha Lothbrok's sword from the series "Vikings". These are the raw prints, but I'm so excited about this build that I wanted to share these WIP photos.
All printed with Esun PETG.
Re: Viking Sword
Posted: Wed Apr 22, 2015 3:14 am
by jsc
What are you using to join the segments on a long piece like that? I imagine the joins would take a beating if that were swung at any velocity and the tip managed to contact something.
Re: Viking Sword
Posted: Wed Apr 22, 2015 3:20 am
by Jules
That's pretty durned awesome!
Re: Viking Sword
Posted: Wed Apr 22, 2015 3:21 am
by jereywolf
jsc wrote:What are you using to join the segments on a long piece like that? I imagine the joins would take a beating if that were swung at any velocity and the tip managed to contact something.
You're absolutely right. I have the entire length supported with two Ø3/16 steel rods. Even with those I advise against hitting anything with it.
Re: Viking Sword
Posted: Tue Apr 28, 2015 12:08 am
by bernardwinston
So great to look at. How did you learn to make such kind of creations dudes.?
Re: Viking Sword
Posted: Tue Apr 28, 2015 12:38 pm
by jereywolf
bernardwinston wrote:So great to look at. How did you learn to make such kind of creations dudes.?
Thank you! I've spent a lot of hours in modeling software.
Re: Viking Sword
Posted: Tue Apr 28, 2015 2:54 pm
by Yodajammies
Wow that looks great! How long was the build time on this prop?
Re: Viking Sword
Posted: Tue Apr 28, 2015 7:31 pm
by jereywolf
Thanks! I think all together it was around 24 hours.
Re: Viking Sword
Posted: Sun May 10, 2015 11:53 pm
by jereywolf
The sword all finished.
Re: Viking Sword
Posted: Mon May 11, 2015 2:13 am
by Slipshine
looks amazing