Page 1 of 1
Client Prototype & GoPro Mount
Posted: Fri Aug 28, 2015 7:20 am
by kartcrg
My printer has been running almost nonstop prototype work (I'm a product designer) such as this
but I snuck in a GoPro mouth mount to snag some FPV shots kiteboarding.
I know its nothing that interesting but I'm loving everything about the M2 and prototyping in-house has taken my business to the next level. Many thanks to people on this forum for helping me get started and thanks to MakerGear for a great product!
Re: Client Prototype & GoPro Mount
Posted: Sat Aug 29, 2015 3:35 am
by rpollack
Wait...you are holding the camera with your mouth?
Do you normally use a mouthpiece when kiteboarding and you just added the camera?
Rick
Re: Client Prototype & GoPro Mount
Posted: Sat Aug 29, 2015 4:30 am
by Matt_Sharkey
rpollack wrote:Wait...you are holding the camera with your mouth?
Do you normally use a mouthpiece when kiteboarding and you just added the camera?
Rick
Some of the bigger "risk-takers" have been using some sort of mouth piece with their go pro for a while now (more often than not, just a generic gopro bracket). You will see it in some surfing videos, the surfer grabbing the camera and then bites down on some sort of mouth piece
I think the design is ingenious to use a snorkel mouthpiece!
Re: Client Prototype & GoPro Mount
Posted: Sat Aug 29, 2015 6:59 pm
by kartcrg
rpollack wrote:
Do you normally use a mouthpiece when kiteboarding and you just added the camera?
Rick
No, I just leave it tucked away and then when I want to grab some footage I can pop it in my mouth for a FPV shot or hold it for shots like this.
Re: Client Prototype & GoPro Mount
Posted: Sun Aug 30, 2015 3:02 am
by rpollack
That looks like a lot of fun!
Re: Client Prototype & GoPro Mount
Posted: Mon Aug 31, 2015 9:15 pm
by kartcrg
rpollack wrote:That looks like a lot of fun!
Yes sir - beats going to the gym
