Steel VS Bronze
Posted: Mon Nov 09, 2015 4:23 am
Lacking the final polish but they came out just pretty well. The bronze looks more copper in this picture.
MakerGear Forum
The Place To Discuss MakerGear 3D Printers!
http://www.forum.makergear.com/
Steel VS Bronze
Page 1 of 1
Re: Steel VS Bronze
Posted: Mon Nov 09, 2015 4:31 am
Those don't even look printed....great job!
Re: Steel VS Bronze
Posted: Mon Nov 09, 2015 5:15 am
Nice !!!
Re: Steel VS Bronze
Posted: Mon Nov 09, 2015 6:12 am
very nice! filament mfg???
Re: Steel VS Bronze
Posted: Mon Nov 09, 2015 6:51 am
Proto-pasta steel and colorfabb bronzefil.jimc wrote:very nice! filament mfg???
Printed at .15mm (the higher the res the better). Put in rock tumbler with steel shot for around 16 hours.
Re: Steel VS Bronze
Posted: Mon Nov 09, 2015 4:59 pm
Beautiful. Did you design those pieces? If so, what software did you use?
cheers,
c
cheers,
c
Re: Steel VS Bronze
Posted: Mon Nov 09, 2015 5:07 pm
Gosh no, my artistic talents are limited to say the least. No these are a stylized version of a well known set called the Lewis Set. You can find this version on thingiverse, simply search for lewis chess. I actually wish there was a modelling done for the original figures as they are fantastic, but I understand the changes made to ease the printing process.Vandal968 wrote:Beautiful. Did you design those pieces? If so, what software did you use?
cheers,
c
Re: Steel VS Bronze
Posted: Mon Nov 09, 2015 10:15 pm
They almost look like carved stone. Nice job!