Page 1 of 1
Villa Loop
Posted: Wed Dec 02, 2015 7:56 pm
by Pekish79
I am adding the link to the STL file
https://www.thingiverse.com/thing:1169341
all piece match perfectly without glue as the base as indentation but the short sloping piece really will tend to move from the correct position as i didn't add an extra support on the cantilever side (because it wouldn't look good)
Re: Villa Loop
Posted: Wed Dec 02, 2015 8:33 pm
by Jules
Fantastic job!
Re: Villa Loop
Posted: Wed Dec 02, 2015 10:29 pm
by jsc
Your trees are looking quite nice now. And those thin window columns came out very good.
Re: Villa Loop
Posted: Thu Dec 03, 2015 1:00 pm
by PcS
Wow !!! Great job !!!
Re: Villa Loop
Posted: Thu Dec 03, 2015 2:09 pm
by Jules
If you ever get to the point where you need or want a darker brown color for your models (like for the ground, or tree trunks), try the eSUN brown PLA. (It's very rich looking.) I love it and use it for dark wood colors.
(And it's a lot easier to print with than the actual wood filaments.)
Re: Villa Loop
Posted: Fri Dec 04, 2015 11:57 pm
by Pekish79
I will look into that i need a dark wood color as there is really no selection in the wood pla for dark color
could you send me a link to the one u think is nice ^_^ sometimes picture on internet don't really show the real color
Re: Villa Loop
Posted: Sat Dec 05, 2015 12:16 am
by Jules
Re: Villa Loop
Posted: Sat Dec 05, 2015 12:26 am
by Pekish79
^_^ ordering one seems pretty dark exactly what i can't find as wood-pla
Re: Villa Loop
Posted: Sat Dec 05, 2015 12:58 am
by Jules
Pekish79 wrote:^_^ ordering one seems pretty dark exactly what i can't find as wood-pla
Yes, it's several orders of magnitude darker than the woods i've seen. (I've been through a couple of rolls so far.)
Re: Villa Loop
Posted: Sat Dec 05, 2015 8:58 pm
by 3d-cafe
Very impressive!