M2E Fan Washer Location?
Posted: Fri Dec 31, 2021 12:49 am
I just had to remove my extruder, and in the process, I had a small black washer fall off the long lower left screw that holds the fans to the extruder & gearbox.
I think the washer goes between the extruder fan and the extruder housing, but it's also possible it is normally located between the angled fan bracket and the extruder fan.
I looked in a bunch of places for any sort of exploded diagram that shows how that all goes together, but I struck out.
Can somebody verify where the washer goes? It shouod be visible from the left side without taking anything apart.
Thanks!
I think the washer goes between the extruder fan and the extruder housing, but it's also possible it is normally located between the angled fan bracket and the extruder fan.
I looked in a bunch of places for any sort of exploded diagram that shows how that all goes together, but I struck out.
Can somebody verify where the washer goes? It shouod be visible from the left side without taking anything apart.
Thanks!