MakerGear Forum

Posted: **Thu Nov 06, 2014 7:43 am**

i read use the lubricant on the z bars, i applied a few drops at the base of the bars and up and down the bars. i believe the x and y need oil as well? i haven't found photos anywhere online where someone shows how to apply this. i dont wanna place oil somewhere its NOT supposed to go.

any help on this i'd be super appreciative.

cheers

Posted: **Thu Nov 06, 2014 9:30 am**

Hi Metrons,

You'll find answers to lots of your questions at the M2 wiki site, including lubricating instructions:

http://makergear.wikidot.com/m2

MakerGear Forum

where exactly do i apply lubricant? using 3 n 1

where exactly do i apply lubricant? using 3 n 1

Re: where exactly do i apply lubricant? using 3 n 1