Brand new hot end not working.
Posted: Fri May 09, 2014 10:29 pm
Hey Everyone!
I just got a brand spank'n new hot end today. I was all excited to get started printing and this happened...
RECEIVED: Error:0
RECEIVED: : Extruder switched off. MINTEMP triggered !
RECEIVED: Error:Printer stopped deu to errors. Fix the error and use M999 to restart!. (Temperature is reset. Set it before restarting)
SENT: M105
Temp reads zero and will not set. (Extruder)
Temp reads 15*c and will not set (HBP)
My old hot end works fine... Do I need to change something in the firmware? Any ideas?
Thanks,
John
I just got a brand spank'n new hot end today. I was all excited to get started printing and this happened...
RECEIVED: Error:0
RECEIVED: : Extruder switched off. MINTEMP triggered !
RECEIVED: Error:Printer stopped deu to errors. Fix the error and use M999 to restart!. (Temperature is reset. Set it before restarting)
SENT: M105
Temp reads zero and will not set. (Extruder)
Temp reads 15*c and will not set (HBP)
My old hot end works fine... Do I need to change something in the firmware? Any ideas?
Thanks,
John