Page 1 of 1
Blown fuse? or fried circuit board?
Posted: Mon Feb 23, 2015 10:42 pm
by majerdave
I had a loose wire on the main "bed' fan that is below the extruder fan. It accidentally shorted and power was cut to the printer (but the M2 power module kept running). I looked and saw a blue 15 fuse that I removed but saw was not shorted. Does this mean board is fried?
Re: Blown fuse? or fried circuit board?
Posted: Mon Feb 23, 2015 10:54 pm
by insta
There's two other fuses onboard. They're really small rectangular beige ones ... I bet one of them died.
Re: Blown fuse? or fried circuit board?
Posted: Wed Feb 25, 2015 12:46 am
by rpollack
Re: Blown fuse? or fried circuit board?
Posted: Wed Feb 25, 2015 6:45 am
by majerdave
Thank you both very much. I found out that one of the two were blown.
But the link shows a leadtime of 10 weeks.
I checked locally an Radioshack or Frye's electonics do not carry them.
Maybe I can find one on Amazon.
Re: Blown fuse? or fried circuit board?
Posted: Wed Feb 25, 2015 6:52 am
by majerdave
Oops, my bad.
The link shows that individual ones can ship immediately.
Re: Blown fuse? or fried circuit board?
Posted: Wed Feb 25, 2015 3:04 pm
by jimc
Newark also has them. Just do a part# search or search nano fuses.
Re: Blown fuse? or fried circuit board?
Posted: Wed Feb 25, 2015 4:38 pm
by rpollack
We usually have some of the fuses in stock, if needed.