Page 1 of 1
Hot end issues
Posted: Thu Oct 29, 2015 11:36 pm
by Amorese128
Ok forum trying to print and nothing is coming out. Using ABS heat is up to 245 , new .50 nozzle. Feeding filament is fine. I removed nozzle and hit extract. filament comes out however it is not reaching the temp to melt it so it will go through nozzle. So I cranked up the temp to 265 and still same issue. Any suggestions why?
Re: Hot end issues
Posted: Fri Oct 30, 2015 2:12 am
by Bratag
Amorese128 wrote:Ok forum trying to print and nothing is coming out. Using ABS heat is up to 245 , new .50 nozzle. Feeding filament is fine. I removed nozzle and hit extract. filament comes out however it is not reaching the temp to melt it so it will go through nozzle. So I cranked up the temp to 265 and still same issue. Any suggestions why?
Possible thermistor issue? Reading high? Is the hotend actually hot?
Re: Hot end issues
Posted: Fri Oct 30, 2015 4:30 am
by Jules
I was just gonna suggest checking the actual nozzle. Manufacturing defects do happen.