MakerGear Forum

Posted: **Mon Nov 06, 2017 11:47 pm**

https://imgur.com/a/wNUk9

I have a M2 Rev E. Every print gets these bumps in the same exact spot. Any ideas?

Posted: **Tue Nov 07, 2017 2:19 am**

They are typically called "zits". Simplify 3D has a very good troubleshooting guide. Here's the section on "blobs & zits":

https://www.simplify3d.com/support/prin ... s-and-zits

Every print I make gets these little raised bumps.