Page 1 of 1
Simplify 3d
Posted: Sun May 31, 2015 5:56 pm
by PcS
Just found this page today after pulling my hair out with the black and white petg constantly jamming. Thought it would be useful as I found it clarified a LOT of things I thought I knew !!! lol
http://forum.simplify3d.com/viewtopic.php?f=8&t=2367
Re: Simplify 3d
Posted: Sun May 31, 2015 7:36 pm
by jimc
yeah kw did a good job of putting that together a couple months ago. did you get your jamming situation under control?
Re: Simplify 3d
Posted: Sun May 31, 2015 11:07 pm
by PcS
It so far....fingers crossed has made it 6 hrs into a 50 hr print. I hope I have. The stuff just gets anything on the nozzle with long infill and long solid runs and it snowballs to a jam inducing clump. Looking clean so far.