MakerGear Forum

This is peeling the support off of a HIPS print, done at 0.2mm layer height. The side support isn't too special, it was just a precaution, since the part was only about 45 degrees there. But, look at the support on the bottom.

https://goo.gl/photos/9LUUNicmZE5DqrUNA

This isn't an M2, but it works just as well on an M2. This is my ONI. My M2s are all busier with more important and less photographable prints

I have to agree - if S3D did nothing else but the support - it would be worth the money.

Secondly - as an Australian I applaud the casual way the abuse was delivered at the end of the clip ... Nice

Focus damn it !!! Lol