Page 1 of 1
SD card question
Posted: Tue Dec 15, 2015 1:00 am
by 747skys
Ok, so I'm a bit new but I thought that printing from the SD card would free up my computer for doing other things. Well I had downloaded my part to my SD card using Simplify 3D and started printing. About the last 30 seconds of the print, I shut down S3D and my printing stopped dead. Am I doing something wrong, or do I need to keep S3D open even though printing from the SD? Anyone have an idea?
Re: SD card question
Posted: Tue Dec 15, 2015 5:41 am
by jsc
Activity over the USB port can trigger a reset. If you want to ensure that nothing will disturb it, disconnect the cable once you've started the print.
Re: SD card question
Posted: Tue Dec 15, 2015 1:41 pm
by SouthSideofdaSky
Welcome to the forum!
Yes, like jsc said you have to pull the USB cable from the printer/computer. Then the printer will be unaffected. Don't use the disconnect button in Simplify3D or do a Safely Remove Hardware, or even close the software with it still connected. Just pull the plug.
Re: SD card question
Posted: Tue Dec 15, 2015 5:22 pm
by 747skys
Thanks, will try that. How about if I don't even open S3D before I start a print from the SD card?
Re: SD card question
Posted: Tue Dec 15, 2015 6:02 pm
by PcS
You need to pull the end cord.
Re: SD card question
Posted: Wed Dec 16, 2015 1:36 pm
by SouthSideofdaSky
747skys wrote:Thanks, will try that. How about if I don't even open S3D before I start a print from the SD card?
Not sure if I understand what you mean. Unless you have the LCD upgrade or some other way of communicating with the printer, you do need S3D's Machine Control Panel to start the print.