Page 1 of 1
simplify3d fff
Posted: Sat Apr 30, 2016 8:16 am
by robkiller
Anyone have a good test and working profile for printing 1.75 mm pla on hot end version v3b? I went from Cura to simplify3d and was trying to not reinvent the hard work someone has already done.
Thanks
Re: simplify3d fff
Posted: Sat Apr 30, 2016 1:41 pm
by Jules
Insta's "Filaments that work" thread have a lot of settings for various filaments - or the "Beginner's Guides" in the How-To forum has specifics for PLA.
Re: simplify3d fff
Posted: Sun May 01, 2016 4:25 am
by robkiller
Thanks I have been looking but have not found and posted fff that I can imputed that are not people just posting looking for what's wrong. I was hoping someone who has pit a lot of time in it would share one. Thanks
Re: simplify3d fff
Posted: Sun May 01, 2016 5:11 am
by Jules
Most people with the older nozzles used the Rsilver profiles:
http://www.thingiverse.com/thing:269637