This is modeled after Lagertha Lothbrok's sword from the series "Vikings". These are the raw prints, but I'm so excited about this build that I wanted to share these WIP photos.
All printed with Esun PETG.
Viking Sword
Viking Sword
- Attachments
-
- lagertha raw PETG.jpg (93.68 KiB) Viewed 14729 times
Re: Viking Sword
What are you using to join the segments on a long piece like that? I imagine the joins would take a beating if that were swung at any velocity and the tip managed to contact something.
Re: Viking Sword
That's pretty durned awesome! 
Re: Viking Sword
You're absolutely right. I have the entire length supported with two Ø3/16 steel rods. Even with those I advise against hitting anything with it.jsc wrote:What are you using to join the segments on a long piece like that? I imagine the joins would take a beating if that were swung at any velocity and the tip managed to contact something.
-
bernardwinston
- Posts: 1
- Joined: Tue Apr 28, 2015 12:06 am
Re: Viking Sword
So great to look at. How did you learn to make such kind of creations dudes.?
Re: Viking Sword
Thank you! I've spent a lot of hours in modeling software.bernardwinston wrote:So great to look at. How did you learn to make such kind of creations dudes.?
-
Yodajammies
- Posts: 17
- Joined: Fri Jan 30, 2015 11:05 pm
Re: Viking Sword
Wow that looks great! How long was the build time on this prop?
Re: Viking Sword
Thanks! I think all together it was around 24 hours.
Re: Viking Sword
The sword all finished.
- Attachments
-
- sm11174226_839529209466508_5207674660006543283_o.jpg
- (398.26 KiB) Downloaded 579 times