The WAVES are back!?!

[Dave K]

When you adjusted height the last time, did you check level as well? That was the root of my issue when I was seeing the same phenomenon. A combination of the nozzle too close to the glass and not being level.

[jimc]

huh, then i guess you have a 24v machine. remove that command out of the line like jin said. usually the fans dont come on with that there but i cant keep track of what was going on there for awhile concerning those thing. too many configurations. keep lowering the bed little by little. it will straighten you out.

[JohnnyRobot]

One more thing... My S3D says I'm up to date and running 2.0.1?

[JohnnyRobot]

When you adjusted height the last time, did you check level as well? That was the root of my issue when I was seeing the same phenomenon. A combination of the nozzle too close to the glass and not being level.

Yep. I've been leveling like a madman over here

[jimc]

no that check for update doesnt work. go here and just download it.

http://www.simplify3d.com/downloads/

[JohnnyRobot]

Ah... Thank you. 2.0.1 Vs 2.1.0

Fot nair for dyslexics

[Toby]

this is a real puzzler. when you set the z-height, do you do it when the bed is up to temp? If not, that could cause a problem because the glass expands and shrinks the gap, especially around those high ABS temperatures for the bed.

about s3d- yeah, they haven't updated the updater. just go to the site and download the new version. i forget if there's anything more to it than that....but the latest version is 2.1. it's worth it to install.

[jimc]

here i just started a print a min ago and it has a wide skirt so i purposely turned my z-height adjustment knob to raise the bed 1 click so you could see what happened because now i am printing too close.

IMG_2970.jpg (134.31 KiB) Viewed 15115 times

[Toby]

in terms of bed adhesion, are you using anything besides bare glass? if not you may end up thinking you have to be closer than you really do to get adhesion.

[jimc]

and here is another of the first layer infill. if i turn the knob and drop the bed 1 click this will print perfectly. of course you want to get your adjustment bolt set and not do it with the knob. i just did it to demonstrate.

IMG_2973.jpg (96.34 KiB) Viewed 15115 times