Killed A 50mm Fan Blade

General discussion topics
Post Reply
CCRN
Posts: 181
Joined: Wed Jun 01, 2016 6:15 pm

Killed A 50mm Fan Blade

Post by CCRN » Wed Jul 27, 2016 4:30 pm

Yesterday was a bad day with clogs and a my Z-offset changed due to a rare bug in the M2 Quickstart I was using to level/start height. David at tech support had to walk me through determining the z-offset and storing it. There is new beta M2 quickstart software I wasn't aware of.

Anyway, I was retracting filament to view and adjust tension per the beginner guide and the filament was under some tension. It came loose and the tip of the filament hit the spinning 50mm fan breaking a blade. :oops: Fortunately I had a spare :D

Some days things just don't go well, but today's prints are going much better!

Jerold
Top
User avatar
sthone
Posts: 897
Joined: Tue Jul 08, 2014 8:25 pm
Location: Connecticut
Contact:
Contact sthone

Re: Killed A 50mm Fan Blade

Post by sthone » Wed Jul 27, 2016 8:31 pm

Been there, done that, then switched to blower type fans. :D
____________________________________________________
See my projects at https://www.theneverendingprojectslist.com
Top
Post Reply

Return to “General Discussion”