So as not to hijack that thread, I'm making a new post. It's not rsilvers' profile, but I've gone through and put together a profile where all the materials/quality buttons work. You have to go in with a text editor and edit the FFF file by hand. If you just export your settings, you only get a single setting. Look for the autoConfigureMaterial and autoConfigureQuality sections. You can stuff in any parameters you want, although I've found that some things don't work (for example, you can't seem to set infillPercentage in an autoConfigureMaterial section).Hey rsilvers! I've been using your M2 optimized profiles from Thingiverse and was wondering if you'd consider making an updated version which uses the new Simplify3D file format and maybe uses one profile with multiple materials and qualities instead of individual profiles for each. I started to compare the existing profiles but wasn't sure which settings were the secret sauce.
I wouldn't advise anyone to use this profile themselves, as it's set up for my own use: dual extruders, PETG in the left and PLA in the right. Selecting PETG or PLA changes all the extruder settings and the temperature profile to the correct extruder, although it doesn't modify the startup code yet. If you want to make your own, export your current favorite profile and perhaps use mine as a guide to add your own material/quality sections.
For people with dual extruders, you have to add a T1 after the G28 homing to use the right extruder in the startup sequence.
So you might want to try that if you've already upgraded.