Steel VS Bronze

Bratag · Post by **Bratag** » Mon Nov 09, 2015 4:23 am

Lacking the final polish but they came out just pretty well. The bronze looks more copper in this picture.

Jules · Post by **Jules** » Mon Nov 09, 2015 4:31 am

Those don't even look printed....great job!

3dPrintingMD · Post by **3dPrintingMD** » Mon Nov 09, 2015 5:15 am

Nice !!!

jimc · Post by **jimc** » Mon Nov 09, 2015 6:12 am

very nice! filament mfg???

Bratag · Post by **Bratag** » Mon Nov 09, 2015 6:51 am

jimc wrote:very nice! filament mfg???

Proto-pasta steel and colorfabb bronzefil.

Printed at .15mm (the higher the res the better). Put in rock tumbler with steel shot for around 16 hours.

Vandal968 · Post by **Vandal968** » Mon Nov 09, 2015 4:59 pm

Beautiful. Did you design those pieces? If so, what software did you use?

cheers,
c

Bratag · Post by **Bratag** » Mon Nov 09, 2015 5:07 pm

Vandal968 wrote:Beautiful. Did you design those pieces? If so, what software did you use?

cheers,
c

Gosh no, my artistic talents are limited to say the least. No these are a stylized version of a well known set called the Lewis Set. You can find this version on thingiverse, simply search for lewis chess. I actually wish there was a modelling done for the original figures as they are fantastic, but I understand the changes made to ease the printing process.

willnewton · Post by **willnewton** » Mon Nov 09, 2015 10:15 pm

They almost look like carved stone. Nice job!

Steel VS Bronze

Steel VS Bronze

Re: Steel VS Bronze

Re: Steel VS Bronze

Re: Steel VS Bronze

Re: Steel VS Bronze

Re: Steel VS Bronze

Re: Steel VS Bronze

Re: Steel VS Bronze