Where is two piece Zstop adjustment

[naturalstate720]

I just bought the M2 a few weeks ago, and yes it never drops. Not when you disable the motor or when the print is done.

What about the two peice zstop adjustment that is plastic? I'm pretty sure I saw it somewhere but can't find it. It allowed you to finger tighten it and I though it went on top, not the bottom.

[Pekish79]

yes mine never drop either and the piece u are looking for is this one

http://www.thingiverse.com/thing:198811

and i would suggest to use this one too as drive for filament

http://www.thingiverse.com/thing:984369

plus i made a better fan solution if u want to use a funnel

http://www.thingiverse.com/thing:1083655

there are 2 funnel one straight one slightly slanted (u can use the black PLA as they stay far enough from the nozzle)
I redone the support for the fan as well i still didn't take a picture on how to mount it but isn't impossible to understand it wrap around the top fan from behind more rigid
(as you remove the old support u will see that the screw is too long and hit the bottom of the run before it tight up the upper fan so you will need to print some spacers)

i promise i will get some picture soon

[naturalstate720]

Thanks Pekish79,
I couldn't find that anywhere.

Have you used the zstop adjustment peice? Can you also put this http://www.thingiverse.com/thing:105616 one on the bottom with the first one you shared? Or is there not a point?

It seems weird to me that the zstop bolt has nothing attached to the bottom thread underneath the plate.

[Pekish79]

no i only use the 2 piece i showed you i kind of find what suite me and stick to it