so just having a small issue after upgrading to the new v4 extruder. The thermistor isn't registering with simplify3d which i quickly figured out was due to the black wire leading into it being smushed down when the hotend is in place, if I take the hotted out and jiggle the wire a little i can get a connection and I think i can get it to stay in a place where it works if I could use some tape, only problem is this thing gets to 250 degrees... any high heat tape or something I could use to secure it?
Thanks
EDIT: nevermind couldn't get it working so i just pulled the old thermistor out of the v3b