Ask the MakerGear community for assistance...
-
Jules
- Posts: 3144
- Joined: Wed Jan 21, 2015 1:36 am
Post
by Jules » Wed Apr 13, 2016 12:24 am
insta wrote:That's a lot of words to say "because I document them".
i document them. (You're so right - that's
MUCH easier!)
What can i say?...i'm a wordy little thing.
(Fixed it.) 
-
w22
- Posts: 56
- Joined: Sun Apr 03, 2016 7:52 am
Post
by w22 » Mon Oct 03, 2016 1:18 pm
Thanks everyone for your support. I figured these noob things out quite a while ago but never replied. All of you are so patient and supportive, thank you so much!
-
grahamsholt
- Posts: 10
- Joined: Mon Aug 15, 2016 5:25 pm
Post
by grahamsholt » Mon Oct 03, 2016 8:37 pm
Thanks again Jules. Just one zip tie to solve another one of those little problems that I don't think about until it catches during a print.
3. The extruder cable continues to get yanked and torn by the beds upper right pin that holds the glass down and is getting close to tearing the internal wires, thoughts? (AKA is there a cap I can print so the power cable can just glide over that corner?).
You didn't see this where I replied on your other thread.....all you need is a zip-tie:
ziptie.jpg
-
Jules
- Posts: 3144
- Joined: Wed Jan 21, 2015 1:36 am
Post
by Jules » Mon Oct 03, 2016 8:40 pm
I discovered it the hard way myself....chuckle!
