Printer (Rev E) not detected by windows

Ask the MakerGear community for assistance...
Kurz009
Posts: 7
Joined: Mon Nov 14, 2016 12:54 am

Re: Printer (Rev E) not detected by windows

Post by Kurz009 » Tue Nov 15, 2016 10:20 pm

3dPrintingMD:
Thank you. At this point I'm thinking the same thing :(

Jules:
I contacted tech support same day I made this thread. So far nothing has worked.

CCRN:
Where'd you get your copy of Octoprint? I DLed it from the main site and it worked, but then if I tried to update it would fail and the OctoPrint server would refuse to load if I rebooted. Do you update through WiFi? I'll try updating through the Ethernet port next time I try it.

theboz1419:
I'll recheck the power connections. I'm sure they are fully connected, but I'll redo them again today.

Thank you all for taking the time to respond.

CCRN
Posts: 181
Joined: Wed Jun 01, 2016 6:15 pm

Re: Printer (Rev E) not detected by windows

Post by CCRN » Sun Nov 20, 2016 5:40 am

I downloaded octopi from https://octopi.octoprint.org/. I used the command line on the mac to format the SD card and use ethernet to connect to the raspberry pi. When an update is indicated, I do it and haven't had any issues.

Post Reply